Wireless Devices:FritzBox3070: Difference between revisions
| Line 18: | Line 18: | ||
** 5 diodes: "Power", "LAN", "WLAN", "DSL", "INFO" |
** 5 diodes: "Power", "LAN", "WLAN", "DSL", "INFO" |
||
= |
= Chips = |
||
''The enclosure can be opened by pressing the brackets with a slotted screwdriver '''towards''' the device.'' |
''The enclosure can be opened by pressing the brackets with a slotted screwdriver '''towards''' the device.'' |
||
| Line 34: | Line 34: | ||
WiFi Card: [http://www.ti.com/litv/pdf/splt139a Texas Instruments TNETW1130 (aka ACX111)] in MiniPCI-like slot |
WiFi Card: [http://www.ti.com/litv/pdf/splt139a Texas Instruments TNETW1130 (aka ACX111)] in MiniPCI-like slot |
||
== Serial Port == |
|||
[http://www.wehavemorefun.de/fritzbox/Serielle_Konsole Pin layout]:<br/> |
|||
* VCC (3.3V)<br/> |
|||
* RX<br/> |
|||
* TX<br/> |
|||
* GND |
|||
The 3.3 Volt pin is the one next to the Atheros miniPCI card. Speed is 38400 bits per second. |
The 3.3 Volt pin is the one next to the Atheros miniPCI card. Speed is 38400 bits per second. |
||
Revision as of 08:57, 7 March 2007
Hardware Interfaces
- Back
- RJ-11 socket DSL
- USB-B socket
- 4 RJ-54 sockets (Ethernet 10/100 Base-T)
- USB-A socket
- Power button
- Power socket
- WLAN button
- Front
- 5 diodes: "Power", "LAN", "WLAN", "DSL", "INFO"
Chips
The enclosure can be opened by pressing the brackets with a slotted screwdriver towards the device.
Broadband Chip: TNETD7300A7DW (aka AR7)
Switch Controller: Infineon ADM6996L
Ethernet Pulse Transformer: UE40ST1041AX-U LF
VLYNQ to USB Bridge: TNETV115PAP
Flash Memory: MX29LV320C (4 MByte)
SDRAM Memory: Qimonda/Infineon HYB39SC256160FE-7 (32 MByte)
WiFi Card: Texas Instruments TNETW1130 (aka ACX111) in MiniPCI-like slot
The 3.3 Volt pin is the one next to the Atheros miniPCI card. Speed is 38400 bits per second.
Changing the Firmware
The development branch of OpenWRT experimentally supports AR7 devices. OpenWRT has been successfully installed on a Fritz!Box SL. The 3070 might require a different flash memory layout.
Changing the memory layout
Original memory layout:
| mtd0 | 0x90000000 | 0x90000000 |
| mtd1 | 0x90010000 | 0x903c0000 |
| mtd2 | 0x90000000 | 0x90010000 |
| mtd3 | 0x903c0000 | 0x903e0000 |
| mtd4 | 0x903e0000 | 0x90400000 |
Links
Fritz!Box Wiki
OpenWRT auf Fritz!Box SL
AR7-Port von OpenWRT
OpenWRT auf Fritz!Box Fon
Speicherlayout Fritz!Box