Wireless-Devices:WRAP-Board

From
Jump to navigation Jump to search

Board: PC-Engines WRAP.2E-128
Daughterboard: USB Extension
Enclosure: WRAP-BOX-2A1E
Wireless Card: Wistron CM9
Pigtail
2 Antenna
PoE Adapter
CF-Card: Kingston CF 1GB

Enabling USB

WRAP-Boards with 5V Input

Normally the WRAP-Boards have 12V Input. Anyway, we have one device where the input voltage has been changed to 5V. To enable USB support for this device you must:

  1. connect USB adapter board to the WRAP-Board
  2. enable USB support in the BIOS of the WRAP-Board:
    1. press "S" during memory test when the WRAP-Board boots up to enter the BIOS
    2. If the menu says "(U)" then this means USB is disabled. Brackets "(U)" mean disabled, and stars "*U*" mean enabled. Press "U" to enable (*U*).
    3. Press "Q" to quit and the answer Yes to save the settings.

Example

Here the USB is disabled in the BIOS, because it is enclosed by Brackets (press U to change this):

(9) 9600 baud *3* 38400 baud (5) 57600 baud
*C* CHS mode (L) LBA mode
(E) Etherboot enable
(U) USB enable
(D) Conservative DRAM timing
*R* Serial console enable
(X) Xmodem upload (Q) Quit

List of Nodes

Note: When built into the chasing, wifi0 is on the lower side and wifi1 on the upper side of the board, wifi1 is on the same side as the compact flash card.

No
eth0-MAC
eth0-IP
0th wifi MAC
0th wifi IP
1st wifi-MAC
1st wifi IP
misc
BIOS upgraded?
1 00:0D:B9:07:61:98 06:0B:6B:56:FD:AA 10.86.253.170 N
2 00:0D:B9:07:67:60 06:0B:6B:09:EF:23 10.9.239.35 N


3 00:0D:B9:07:61:A4 06:0C:42:0C:85:A8 10.12.133.168 N
4 00:0D:B9:07:67:54 06:0B:6B:56:FF:B8 10.86.255.184 N
5 00:0D:B9:07:67:78 06:0B:6B:57:01:2B 10.87.1.43 N
6 00:0D:B9:07:67:7C 06:0C:42:0C:74:18 10.12.116.24 N


7 00:0D:B9:07:67:88 00:0C:42:0C:74:2F 10.12.116.47 00:0C:42:0C:85:9C 10.12.133.156 N
8 00:0D:B9:05:B4:08 06:0C:42:0C:74:1B 10.12.116.27 00:0C:42:0C:85:BB 10.12.133.187 5 V device with USB Y


Links

Kingston Flash Memory Guide