Wireless-Devices:WRAP-Board
Jump to navigation
Jump to search
Board: PC-Engines WRAP.2E-128
Daughterboard: USB Extension
Enclosure: WRAP-BOX-2A1E
Wireless Card: Wistron CM9
Pigtail
2 Antenna
PoE Adapter
CF-Card: Kingston CF 1GB
Enabling USB
WRAP-Boards with 5V Input
Normally the WRAP-Boards have 12V Input. Anyway, we have one device where the input voltage has been changed to 5V. To enable USB support for this device you must:
- connect USB adapter board to the WRAP-Board
- enable USB support in the BIOS of the WRAP-Board:
- press "S" during memory test when the WRAP-Board boots up to enter the BIOS
- If the menu says "(U)" then this means USB is disabled. Brackets "(U)" mean disabled, and stars "*U*" mean enabled. Press "U" to enable (*U*).
- Press "Q" to quit and the answer Yes to save the settings.
Example
Here the USB is disabled in the BIOS, because it is enclosed by Brackets (press U to change this):
(9) 9600 baud *3* 38400 baud (5) 57600 baud
*C* CHS mode (L) LBA mode
(E) Etherboot enable
(U) USB enable
(D) Conservative DRAM timing
*R* Serial console enable
(X) Xmodem upload (Q) Quit
List of Nodes
Note: When built into the chasing, wifi0 is on the lower side and wifi1 on the upper side of the board, wifi1 is on the same side as the compact flash card.
| 1 | 00:0D:B9:07:61:98 | 06:0B:6B:56:FD:AA | 10.86.253.170 | N | ||||
| 2 | 00:0D:B9:07:67:60 | 06:0B:6B:09:EF:23 | 10.9.239.35 | N
| ||||
| 3 | 00:0D:B9:07:61:A4 | 06:0C:42:0C:85:A8 | 10.12.133.168 | N | ||||
| 4 | 00:0D:B9:07:67:54 | 06:0B:6B:56:FF:B8 | 10.86.255.184 | N | ||||
| 5 | 00:0D:B9:07:67:78 | 06:0B:6B:57:01:2B | 10.87.1.43 | N | ||||
| 6 | 00:0D:B9:07:67:7C | 06:0C:42:0C:74:18 | 10.12.116.24 | N
| ||||
| 7 | 00:0D:B9:07:67:88 | 00:0C:42:0C:74:2F | 10.12.116.47 | 00:0C:42:0C:85:9C | 10.12.133.156 | N | ||
| 8 | 00:0D:B9:05:B4:08 | 06:0C:42:0C:74:1B | 10.12.116.27 | 00:0C:42:0C:85:BB | 10.12.133.187 | 5 V device with USB | Y
|