BRN:Software:Build and Distribution:Userland Debugging

Debug Setup

The remove debugging setup consists of a debugger stub (named gdbserver), which runs on the target machine (mipsel in our case) and is attached to the debuggee process. The debugger resists on a (remove) host machine and is connectet to the stub via a TCP/IP or serial connection. At first we have to build both a debugger stub and a cross-debugger (note that the host debugger which is shipped with the linux distribution could not be used for cross debugging).

• Build the gdbserver. It must be configured for host and target mipsel.
• Build the cross-gdb. Configure it for target mipsel and host i386.

Precompiled binaries could be found in the NFS rootfs and in /usr/local/bin/mipsel-linux-uclibc-gdb on nfs-student.

Debugging Userland Applications

• At first, start the gdbserver on the mips. You can either specify an executable which is load or attach it to a running process. To debug a process with PID 333 for example, simply type

wgt30$ gdbserver :2000 --attach 333

The debugger stub is now attached to the process with given PID and reachable on TCP port 2000.

• Start the cross-debugger on the host system and connect it to the stub, e.g.

(gdb) target remote wgt30:2000

It may be the case that the gdb does not find the images of the linked-in shared libraries, since host and target system may differ. As a result, the debugger is not able to exermine the stack correctly and no (of no usefull) backtrace could be generated. You can solve this problem by specifying a shared object lookup prefix using the following command:

(gdb) set solib-absolute-prefix /openwrtroot/gdb/lib

This must be done every time you attach to a process.

Now you should be able to use the remote debugger in the same was as a local debugger.